previous next Up Title Contents

Screen Output.

Starting Test Harness...
Reading parameters from file: AudPerSS.par
This test routine calculates the response of a model.
This simulation is run from the specification in file 'Meddis86.sim'.

ReadPars_Utility_SimulationSpec: Reading from 'Meddis86.sim':
ReadPars_PureTone: Reading from 'PTone1.par':
ReadPars_PreEmphasis_BandPass: Reading from 'PreEmph1.par':
ReadPars_IHC_Meddis86: Reading from 'Meddis86.par':
Simulation Specification Utility Module Parameters:-
	Simulation instruction list:-
		Process: 	PureTone <	PTone1.par
		Process: 	PreEmphasis_BandPass <	PreEmph1.par
		Process: 	IHC_Meddis86 <	Meddis86.par
	Diagnostics mode = ON,	Ramp interval = 2.5 ms
Starting test harness...
Pure Tone Module Parameters:-
	Frequency = 1000 Hz,	Intensity = 20 dB SPL,
	Duration = 20 ms,	Sampling interval = 0.05 ms
Preemphasis Band Pass Filter Module Parameters:-
	Filter order = 2,	Pre-attenuation = 0 dB
	Lower/Upper cut-off Frequencies = 450 / 8500 Hz.
Meddis 86 IHC Synapse Module Parameters:-
	Permeability constant, A = 100,	and B = 6000
	Release rate, g = 2000 /s,	Replenishment rate, y = 5.05 /s
	Loss rate, l = 2500 /s,	Reprocessing rate, x = 66.31 /s
	Recovery rate, r = 6580 /s,	 Firing rate, h = 50000 spikes/s
	Maximum transmitter packets in free pool, M = 1.
Output sent to file 'output.dat'.
The process took 0.06 CPU seconds to run.
Finished test.

The screen output shows the diagnostics produced by the driving program. The program starts with a few lines which indicate that the program is starting and the main file from which the programs main parameters are read. It then goes on to give a an explanation of what the program is doing: running the simulation specification found in the `Meddis86.sim' file (this is in the lutear/Examples directory).

What then follows is the result of the driving program printing the diagnostics from the running of the simulation specification.


previous next Up Title Contents